Kitchen Table
So here is my latest creation. It's a two person kitchen table. It's made out of pine and amazingly enough I made it from some 2x4 left overs and a 2x6x8 and two 1x10x4 pieces. All in all the whole...
View ArticleRe: Kitchen Table
Did a 1x4 cross piece at the top between the 2x6 legs and then did four screws with glue. Then on the top tapered supports there are two screws on each side. So have a total number of eight screws and...
View ArticleButternut Desk
So here it is. A desk I just got done putting together for someone special. It's made of Butternut wood. I used a oil based poly on it and that's it. I used the template for this desk from this month's...
View ArticleNew Book/CD/DVD Cabinet
Started making sawdust again..... Starting to make a new book/dvd/cd cabinet for the living room. So far this is a picture of the glued up boards that will become the sides. The center part of the...
View ArticleRe: New Book/CD/DVD Cabinet
Cool ... Great to hear your back in the shop .. keep us updated
View ArticleHey!
Hi, hows it going everyone, I'm Chris- Uhh, a little info about me- I live in FDL, close to Ravinheart, and I am a beginner woodworker, although I've been dabbling in my dad/grandpas shop for many...
View ArticleRe: Hey!
Hey Chris ... Welcome to the forum ... It is not used all that much yet, but, feel free to spread the word and use it as much as you like ...
View ArticleRe: Hey!
Ok sounds good! I do my best for ya, my bad though, I managed to double post this topic :/
View ArticleWorkbench
Ok, so you may have seen that I was/am working on a DVD/CD/Book cabinet; well I got sidetracked. My shop has been a work in progress and I never had a true workbench. So this past weekend I put...
View ArticleRe: Workbench
Ended up doing 5 inches on center. Did that because my vise has about a 7 inch travel. So all in all it worked out well.
View ArticleNeed to Upgrade Table Saw; sell existing
Here is a link to the older table saw that I am looking to sell. http://appleton.craigslist.org/tls/3184288493.html I am looking to upgrade to something that has an extension table that will allow me...
View ArticleFeatherboards
I wanted to get some featherboards to attach to the fence on the table saw just to help hold the board down better; yes, I could make them but that takes away from time of completing my actual project....
View ArticleRe: Featherboards
I use a magnetic version of a featherboard that applies pressure pushing the board into the fence and has an attachment to put pressure downward on the board as well. I have a few other ones too , but,...
View Article
More Pages to Explore .....